Detecting the effects of transient faults is a key point in many processor-based safety-critical applications. This paper proposes to adopt the debug interface module existing today in several processors/controllers available on the market. In this way, we can achieve a good detection capability and small latency with respect to control flow errors, while the cost for adopting the proposed technique is rather limited and does not involve any change either in the processor hardware or in the application software. The method works even if the processor uses caches and we experimentally evaluated its characteristics demonstrating the advantages and showing the limitations on two pipelined processors. Experimental results performed by fault injection using different software applications demonstrate that the method is able to archieve high fault coverage (more than 95 percent in nearly all the considered cases) with a limited cost in terms of area and performance degradation.

Transient faults can affect the behavior of electronic systems, and represent a major issue in many safety-critical applications. This paper focuses on Control Flow Errors (CFEs) and extends a previously proposed method, based on the usage of the debug interface existing in several processors/controllers. The new method achieves a good detection capability with very limited impact on the system development flow and reduced hardware cost: moreover, the proposed technique does not involve any change either in the processor hardware or in the application software, and works even if the processor uses caches. Experimental results are reported, showing both the advantages and the costs of the method.

Detecting the effects of transient faults is a key point in many safety-critical applications. This paper explores the possibility of using for this purpose the debug interface existing today in several processors/controllers on the market. In this way one can achieve a good detection capability with respect to control flow errors with very small latency, while the cost for adopting the proposed technique is rather limited and does not involve any change either in the processor hardware or in the application software. The method works even if the processor uses caches. Experimental results are reported, showing both the advantages and the costs of the method.