We present the architecture for an 802.15.4 receiver that enables battery-free operation. To reach micro-power consumption, the architecture diverges from that of commodity receivers in the following ways: First, similar to backscatter transmitters, it offloads the power-hungry local oscillator to an external device. Second, we avoid the energy cost of demodulating a phase-modulated signal by treating 802.15.4 as a frequency-modulated one, allowing us to receive with a simple passive detector and an energy-efficient thresholding circuit. We demonstrate an off-the-shelf prototype of our receiver receives 802.15.4 from a distance of 470 cm with the carrier generator 30 cm away. This range is sufficient to integrate with deployed wireless sensor networks (WSNs). We demonstrate this integration by pairing our receiver with a 802.15.4 backscatter transmitter and integrating it with unmodified commodity sensor nodes running the TSCH protocol.

We present the architecture of an 802.15.4 receiver that, for the first time, operates at a few hundred microwatts, enabling new battery-free applications. To reach the required micro-power consumption, the architecture diverges from that of commodity receivers in two important ways. First, it offloads the power-hungry local oscillator to an external device, much like backscatter transmitters do. Second, we avoid the energy cost of demodulating a phase-modulated signal by treating 802.15.4 as a frequency-modulated one, which allows us to receive with a simple passive detector and an energy-efficient thresholding circuit. We describe a prototype that can receive 802.15.4 frames with a power consumption of 361 μW. Our receiver prototype achieves sufficient communication range to integrate with deployed wireless sensor networks (WSNs).We illustrate this integration by pairing the prototype with an 802.15.4 backscatter transmitter and integrating it with unmodified 802.15.4 sensor nodes running the TSCH and Glossy protocols.

The sensing capabilities of most sensor networks are fixed at the time of deployment. Adding new sensing capabilities to such networks is a costly and cumbersome process. We present Passive Sensor Tags, battery-free sensing devices that could be used to extend the sensing capabilities of an existing network. Sensor tags feature our new 802.15.4 receiver design which is suitable for micro-power operation, making battery-free tags possible. Because our tags can both transmit and receive 802.15.4 frames there is no need for any modification to the deployed hardware. We present preliminary measurements of transmission and reception range.

In wireless networks that operate in those bands where spectrum sharing occurs across a variety of wireless technologies, such as the license-free Industrial Scientific and Medical (ISM) bands, mitigating interference becomes challenging. Addressing interference is an important aspect for the design and development of solutions intended to satisfy the demands of applications requiring QoS guarantees. In this paper, we investigate dynamic radio resource adaptation techniques based on instantaneous spectrum usage. Using a novel metric to quantify the spectrum usage, we address packet size and error correction code overhead optimizations. On one hand, large payloads lead to energy and throughput gains due to the amortization of the transmission overheads, but on the other hand, larger payloads imply larger resource wastage in the event of packet collisions. Using real-world data, we found that payload size in the neighbourhood of 100 bytes leads to near-optimal performance in general in the IEEE 802.15.4 networks. Our data also shows that for very high interference scenarios, erasure codes capable of correcting 10% of the packet payload can provide an equivalent Signal to Interference plus Noise Ratio (SINR) gain of 25 dB with probability greater than 0.6. This is significant for interference management and for increasing spatial re-use by employing lower transmission power. We show that erasure codes drastically improve energy-efficiency and throughput of low-power wireless links. In the heavy interference regime, even though interference doubles the energy-per-usable-bit cost, erasure codes remain cost-effective for very large payload sizes, up-to 1500 bytes. Finally, we discuss interference-dependent dynamic adjustment of the correction capacity of erasure codes.