Near-field (NF) line-of-sight (LoS) MIMO systems enable efficient channel state information (CSI) acquisition and precoding by exploiting known antenna geometries at both the base station (BS) and user equipment (UE). This paper introduces a compact parameterization of the NF LoS MIMO channel using two angles of departure (AoDs) and a BS-UE relative rotation angle. The inclusion of the second AoD removes the need for fine-grained distance grids imposed by conventional NF channel parametrization. To address the user-specific uplink pilot overhead in multiuser NF CSI acquisition, we propose a scheme that uses a fixed, UE-independent set of downlink pilots transmitted from a carefully selected subset of BS antennas. In dominant LoS conditions, as few as four pilots suffice, with Cramér-Rao bound (CRB) analysis confirming that increased antenna spacing improves estimation accuracy. Each UE estimates and quantizes angular parameters related to NF LoS MIMO channel and feeds them back to the BS for geometry-based CSI reconstruction, eliminating the need for full channel feedback. To enhance robustness against noise, quantization errors, and additional non-line-of-sight (NLoS) components, we introduce a two-stage precoding method. The initial precoding is computed from estimated LoS CSI and refined through bidirectional over-the-air (OTA) training. Furthermore, a two-step stream allocation strategy reduces pilot and computational overhead. Simulations demonstrate that the proposed approach achieves high data rates with significantly fewer OTA iterations, approaching the performance of perfect CSI.

This paper addresses the problem of uplink transmit power optimization in distributed massive multiple-input multiple-output systems, where remote radio heads (RRHs) are equipped with 1-bit analog-to-digital converters (ADCs). First, in a scenario where a single RRH serves a single user equipment (UE), the signal-to-noise-and-distortion ratio (SNDR) is shown to be a non-monotonic and unimodal function of the UE transmit power due to the quantization distortion (QD). Upon the introduction of multiple RRHs, adding properly tuned dithering at each RRH is shown to render the SNDR at the output of the joint receiver unimodal. In a scenario with multiple RRHs and UEs, considering the non-monotonic nature of the signal-to-interference-plus-noise-and-distortion ratio (SINDR), both the UE transmit powers and the RRH dithering levels are jointly optimized subject to the min-power and max-min-SINDR criteria, while employing Bussgang-based maximum ratio combining (BMRC) and minimum mean squared error (BMMSE) receivers. To this end, gradient and block coordinate descent methods are introduced to tune the UE transmit powers, whereas a line search coupled with gradient updates is used to adjust the RRH dithering levels. Numerical results demonstrate that jointly optimizing the UE transmit power and the RRH dithering levels can significantly enhance the system performance, thus facilitating joint reception from multiple RRHs across a range of scenarios. Comparing the BMMSE and BMRC receivers, the former offers a better interference and QD alleviation while the latter has a lower computational complexity.

This paper explores the data-aided regularization of the direct-estimate combiner in the uplink of a distributed multiple-input multiple-output system. The network-wide combiner can be computed directly from the pilot signal received at each access point, eliminating the need for explicit channel estimation. However, the sample covariance matrix of the received pilot signal that is used in its computation may significantly deviate from the actual covariance matrix when the number of pilot symbols is limited. To address this, we apply a regularization to the sample covariance matrix using a shrinkage coefficient based on the received data signal. Initially, the shrinkage coefficient is determined by minimizing the difference between the sample covariance matrices obtained from the received pilot and data signals. Given the limitations of this approach in interference-limited scenarios, the shrinkage coefficient is iteratively optimized using the sample mean squared error of the hard-decision symbols, which is more closely related to the actual system’s performance, e.g., the symbol error rate (SER). Numerical results demonstrate that the proposed regularization of the direct-estimate combiner significantly enhances the SER, particularly when the number of pilot symbols is limited.

Near-field MIMO channels comprising line-of-sight (LoS) dominant paths can be fully described by the angle of arrivals (AoAs) and the rotation angles of both the user equipment (UE) and base station (BS), exploiting their respective antenna geometries. The resulting geometric characterization of the high-rank channels remains independent of the antenna array placement and size at both BS and UEs. Conventional near-field channel estimation requires UE-specific uplink pilots, leading to a significant pilot overhead as the number of UEs increases. In this paper, an alternative near-field MIMO channel reconstruction approach is proposed, relying on a minimal number of downlink pilots and limited geometry (angles, antenna placement) information exchange. Based on the downlink pilots transmitted from the outermost BS antennas and the prior information about the inter-antenna distance, the UEs may estimate the AoAs and rotation angles which in turn are quantized and fed back to the BS. Simulation results illustrate that just two downlink pilots suffice to characterize the channel geometry at the UEs accurately. Furthermore, an 8-bit quantization is adequate for relaying two AoAs and a rotation angle value from the UEs to the BS for full near-field LoS MIMO channel reconstruction given the known antenna placement.

We propose fully distributed multi-group multicast precoding designs for cell-free massive multiple-input multiple-output (MIMO) systems with modest training overhead. We target the minimization of the sum of the maximum mean squared errors (MSEs) over the multicast groups, which is then approximated with a weighted sum MSE minimization to simplify the computation and signaling. To design the joint network-wide multi-group multicast precoders at the base stations (BSs) and the combiners at the user equipments (UEs) in a fully distributed fashion, we adopt an iterative bi-directional training scheme with UE- and/or group-specific precoded uplink pilots and group-specific precoded downlink pilots. To this end, we introduce a new group-specific over-the-air uplink training resource that entirely eliminates the need for backhaul signaling for the channel state information (CSI) exchange. The precoders are optimized locally at each BS by means of either best-response or gradient-based updates, and the convergence of the two approaches is analyzed with respect to the centralized implementation with perfect CSI. Finally, numerical results show that the proposed distributed methods greatly outperform conventional cell-free massive MIMO precoding designs that rely solely on local CSI.

We consider the problem of uplink power control for distributed massive multiple-input multiple-output systems where the base stations (BSs) are equipped with 1-bit analog-to-digital converters (ADCs). The scenario with a single user equipment (UE) is first considered to provide insights into the signal-to-noise-and-distortion ratio (SNDR). With a single BS, the SNDR is a unimodal function of the UE transmit power. With multiple BSs, the SNDR at the output of the joint combiner can be made unimodal by adding properly tuned dithering at each BS. As a result, the UE can be effectively served by multiple BSs with 1-bit ADCs. Considering the signal-to-interference-plus-noise-and-distortion ratio (SINDR) in the multi-UE scenario, we aim at optimizing the UE transmit powers and the dithering at each BS based on the min-power and max-min-SINDR criteria. To this end, we propose three algorithms with different convergence and complexity properties. Numerical results show that, if the desired SINDR can only be achieved via joint combining across multiple BSs with properly tuned dithering, the optimal UE transmit power is imposed by the distance to the farthest serving BS (unlike in the unquantized case). In this context, dithering plays a crucial role in enhancing the SINDR, especially for UEs with significant path loss disparity among the serving BSs.

Unmanned aerial vehicles (UAVs) are the emerging vital components of millimeter wave (mmWave) wireless systems. Accurate beam alignment is essential for efficient beam based mmWave communications of UAVs with base stations (BSs). Conventional beam sweeping approaches often have large overhead due to the high mobility and autonomous operation of UAVs. Learning-based approaches greatly reduce the overhead by leveraging UAV data, like position to identify optimal beam directions. In this paper, we propose a deep Q-Network(DQN)-based framework for uplink UAV-BS beam alignment where the UAV hovers around 5G new radio (NR) BS coverage area, with varying channel conditions. The proposed learning framework uses the location information and maximize the beamforming gain upon every communication request from UAV inside the multi-location environment. We compare the proposed framework against multi-armed bandit (MAB)-based and exhaustive approaches, respectively and then analyse its training performance over different coverage area requirements, antenna configurations and channel conditions. Our results show that the proposed framework converge faster than the MAB-based approach and comparable to traditional exhaustive approach in an online manner under real-time conditions. Moreover, this approach can be further enhanced to predict the optimal beams for unvisited UAV locations inside the coverage using correlation from neighbouring grid locations.

We consider multi-group multicast precoding designs for cell-free massive multiple-input multiple-output (MIMO) systems. To optimize the transmit and receive beamforming strategies, we focus on minimizing the sum of the maximum mean squared errors (MSEs) over the multicast groups, which is then approximated with the sum MSE to simplify the computation and signaling. We adopt an iterative bi-directional training scheme with uplink and downlink precoded pilots to cooperatively design the multi-group multicast precoders at each base station and the combiners at each user equipment in a distributed fashion. An additional group-specific uplink training resource is introduced, which entirely eliminates the need for backhaul signaling for channel state information (CSI) exchange. We also propose a simpler distributed precoding design based solely on group-specific pilots, which can be useful in the case of scarce training resources. Numerical results show that the proposed distributed methods greatly outperform conventional cell-free massive MIMO precoding designs that rely solely on local CSI.

In this paper, assuming multi-antenna transmitter and receivers, we consider a multicast beamformer design for the weighted max-min-fairness (WMMF) problem in a multi-stream multi-group communication setup. Unlike the single-stream scenario, the WMMF objective in this setup is not equivalent to maximizing the minimum weighted SINR due to the summation over the rates of multiple streams. Therefore, the non-convex problem at hand is first approximated with a convex one and then solved using Karush-Kuhn-Tucker (KKT) conditions. Then, a practically appealing closed-form solution is derived for both transmit and receive beamformers as a function of dual variables. Finally, we use an iterative solution based on the sub-gradient method to solve for the mutually coupled and interdependent dual variables. The proposed solution does not rely on generic solvers and does not require any bisection loop for finding the achievable rate of various streams. As a result, it significantly outperforms the state-of-art in terms of computational cost and convergence speed.

Unmanned aerial vehicles (UAVs) are the emerging vital components of millimeter wave (mmWave) wireless systems. Accurate beam alignment is essential for efficient beam based mmWave communications of UAVs with base stations (BSs). Conventional beam sweeping approaches often have large overhead due to the high mobility and autonomous operation of UAVs. Learning-based approaches greatly reduce the overhead by leveraging UAV data, like position to identify optimal beam directions. In this paper, we propose a reinforcement learning (RL)-based framework for UAV-BS beam alignment using deep Q-Network (DQN) in a mmWave setting. We consider uplink communications where the UAV hovers around 5G new radio (NR) BS coverage area, with varying channel conditions. The proposed learning framework uses the location information to maximize data rate through the optimal beam-pairs efficiently, upon every communication request from UAV inside the multi-location environment. We compare our proposed framework against Multi-Armed Bandit (MAB) learning-based approach and the traditional exhaustive approach, respectively and also analyse the training performance of DQN-based beam alignment over different coverage area requirements and channel conditions. Our results show that the proposed DQN-based beam alignment converge faster and generic for different environmental conditions. The framework can also learn optimal beam alignment comparable to the exhaustive approach in an online manner under real-time conditions.

Cell-Free massive MIMO system performance can be improved with cooperative beamforming strategies. Typically, local beamforming strategies are assumed at base stations (BSs) to avoid extensive channel state information exchange via backhaul links. A fully distributed framework relying on a novel over-the-air (OTA) signaling mechanism has been recently proposed to design cooperative beamformers for cell-free massive MIMO systems. However, the existing distributed exact solution has a suboptimal global convergence behaviour because of outdated information used at each BS. This paper proposes a Newton method with an adaptive regularization to design uplink receivers for the fully distributed framework. Numerical results show a significantly faster convergence of the proposed method compared to the distributed exact solution and gradient methods.

Most works on cell-free massive multiple-input multiple-output (MIMO) consider non-cooperative precoding strategies at the base stations (BSs) to avoid extensive channel state information (CSI) exchange via backhaul signaling. However, considerable performance gains can be accomplished by allowing coordination among the BSs. This paper proposes the first distributed framework for cooperative precoding design in cell-free massive MIMO (and, more generally, in joint transmission coordinated multi-point) systems that entirely eliminates the need for backhaul signaling for CSI exchange. A novel over-the-air (OTA) signaling mechanism is introduced such that each BS can obtain the same cross-term information that is traditionally exchanged among the BSs via backhaul signaling. The proposed distributed precoding design enjoys desirable flexibility and scalability properties, as the amount of OTA signaling does not scale with the number of BSs or user equipments. Numerical results show fast convergence and remarkable performance gains as compared with non-cooperative precoding design. The proposed scheme can also outperform the centralized precoding design under realistic CSI acquisition.