A scalable fault management system, including fault detection and localization capability, is crucial for future all-optical networks. In our previous work [5-7], we have proposed adaptive fault diagnosis schemes that deploy proactive lightpath probes to identify network failures, and have developed an asymptotically optimal run-length probing scheme to minimize the diagnostic effort (i.e., the number of lightpath probes). In this research, we aim to investigate the diagnostic hardware cost, i.e., the cost resulted from transmitter/receiver (Tx/Rx) pairs for probe transmission and detection. As a benchmark, we first show that, in order to identify all possible network failures, all the network nodes have to be equipped with diagnostic Tx/Rx pairs. We then develop a probabilistic analysis framework to characterize the trade-off between hardware cost (i.e., the number of nodes equipped with Tx/Rx pairs) and diagnosis capability (i.e., the probability of successful failure detection and localization). Our results suggest that, for practical situations, the hardware cost can be reduced significantly by accepting a small amount of uncertainty about the failure status.

Most existing wavelength-division multiplexed (WDM) networks employ circuit switching, typically with one session having exclusive use of one entire wavelength. Consequently, they are not suitable for data applications involving bursty traffic patterns. The All-Optical Network (AON) Consortium has developed an all-optical LAN/MAN test bed which provides time-slotted WDM service. We explore extensions of this service to achieve fine-grained statistical multiplexing with different virtual circuits time sharing the wavelengths in a fair manner. We develop a very fast, best effort time-slotted WDM network protocol with very good fairness and throughput characteristics. As an additional design feature, our protocol supports the assignment of guaranteed bandwidths (GBW) to selected sessions. This feature acts as a first step toward supporting integrated services at the optical layer in WDM networks.

We describe recent results of the Advanced Research Projects Agency (ARPA) sponsored Consortium on Wideband All-Optical Networks which is developing architectures, technology components, and applications for ultrafast 100 Gb/s time-division multiplexing (TDM) optical networks. The shared-media ultrafast networks we envision are appropriate for providing low-access-delay bandwidth on demand to both future high-burst rate (100 Gb/s) users as well aggregates of lower-rate users (i.e., a heterogeneous user population). To realize these goals we are developing ultrafast network architectures such as HLAN, described here, that operate well in high-latency environments and require only limited processing capability at the ultrafast bit rates. We also describe results on 80-Gb/s, 90-km soliton transmission, 100-Gb/s soliton compression laser source technology, picosecond short-pulse fiber ring lasers, picosecond-accuracy optical bit-phase sensing and clock recovery, all-optical injection-locked fiber figure-eight laser clock recovery, short-pulse fiber loop storage, and all-optical pulse width and wavelength conversion.

We describe some of the results of the Advanced Research Projects Agency (ARPA) sponsored Consortium on Wideband All-Optical Networks in developing architectures, technology components, and applications for the realization of scaleable, wideband, and transparent optical wavelength-division multiplexing (WDM) networks. Our architecture addresses all-optical transport over the wide, metropolitan, and local areas. It utilizes wavelength partitioning, routing, and active multiwavelength cross-connect switches to achieve a network that is scaleable in the number of users, data rates, and geographic span. The network supports two services which can be point-to-multipoint or multipoint-to-multipoint simplex or duplex connections. The A service is a transparent physically circuit-switched service and the B-service is a scheduled time-slotted circuit which is transparent within its time slots. We have developed a 20-channel local and metropolitan area WDM testbed deployed in the Boston area, now undergoing characterization and experimental applications.

Design considerations for an optical spatial tracking system for both coherent and noncoherent heterodyne detection are addressed. Heterodyne detection systems are much less susceptible to background radiation and device noise than conventional direct detection systems. In addition, the angle discriminator profile in a heterodyne detection system can be tailored via the local oscillator spatial distribution. An optimal LO distribution is described and its performance is compared to some Suboptimal distributions. It is shown that an ideal quadrant detector can achieve near optimal performance, since the LO effectively acts like a continuum of detectors. Cramer-Rao tracking bounds and other performance criteria are given under the conservative assumption that the angular process to be tracked is a single-pole process. The method used is directly applicable to other types of angular processes. Experimental verification of some of the basic concepts is presented.