Humans systematically adapt their strategies for closed-loop control based on visual feedback according to the dynamics of the system. Tactile feedback is a key element in many human–machine interfaces, but it is not known if and how well human control adapts to changes in system dynamics when information about the system state is provided using this type of feedback. In this study, 11 participants tracked a pseudorandom trajectory with a virtual, position- or velocity-controlled plant using a joystick. Visual or electrotactile feedback provided the instantaneous error between the target and generated trajectory. Frequency-domain system identification indicated that human control adapted in similar ways to the different control modes (i.e., position/velocity control) for both feedback modalities. For the plant dynamics modeled as gain and integrator, the human controller behaved as a low-pass filter and gain, respectively (under the assumption of quasi-linear behavior). However, while tracking quality was largely similar for both control modes with visual feedback, velocity control enabled substantially worse control with electrotactile feedback compared to position control. Furthermore, for both control modes, the crossover frequency of open-loop transfer functions was lower for electrotactile feedback (0.9 and 1.1 rad/s) than for visual feedback (1.5 and 1.7 rad/s) indicating limited control bandwidth. To summarize, closed-loop control based on electrotactile feedback enables natural adaptations in human control strategy, which is encouraging for tactile feedback-controlled human–machine interfaces, but the lower control bandwidth and lower tracking quality with velocity control may impose functional limitations.

The rectified surface EMG signal is commonly used as an estimator of the neural drive to muscles and therefore to infer sources of synaptic input to motor neurons. Loss of EMG amplitude due to the overlap of motor unit action potentials (amplitude cancellation), however, may distort the spectrum of the rectified EMG and thereby its correlation with the neural drive. In this study, we investigated the impact of amplitude cancelation on this correlation using analytical derivations and a computational model of motor neuron activity, force, and the EMG signal. First, we demonstrated analytically that an ideal rectified EMG signal without amplitude cancellation (EMGnc) is superior to the actual rectified EMG signal as estimator of the neural drive to muscle. This observation was confirmed by the simulations, as the average coefficient of determination (r2) between the neural drive in the 1-30 Hz band and EMGnc (0.59±0.08) was matched by the correlation between the rectified EMG and the neural drive only when the level of amplitude cancellation was low (<40%) at low contraction levels (<5% of maximum voluntary contraction force; MVC). This correlation, however, decreased linearly with amplitude cancellation (r = -0.83) to values of r2 <0.2 at amplitude cancellation levels >60% (contraction levels >15% MVC). Moreover, the simulations showed that a stronger (i.e. more variable) neural drive implied a stronger correlation between the rectified EMG and the neural drive and that amplitude cancellation distorted this correlation mainly for low-frequency components (<5 Hz) of the neural drive. In conclusion, the results indicate that amplitude cancellation distorts the spectrum of the rectified EMG signal. This implies that valid use of the rectified EMG as an estimator of the neural drive requires low contraction levels and/or strong common synaptic input to the motor neurons.

Tremor is the most prevalent movement disorder, and its incidence is increasing with aging. In spite of the numerous therapeutic solutions available, 65% of those suffering from upper limb tremor report serious difficulties during their daily living. This gives rise to research on different treatment alternatives, amongst which wearable robots that apply selective mechanical loads constitute an appealing approach. In this context, the current work presents a multimodal human-robot interface to drive a neuroprosthesis for tremor management. Our approach relies on the precise characterization of the tremor to modulate a functional electrical stimulation system that compensates for it. The neuroprosthesis is triggered by the detection of the intention to move derived from the analysis of electroencephalographic activity, which provides a natural interface with the user. When a prediction is delivered, surface electromyography serves to detect the actual onset of the tremor in the presence of volitional activity. This information in turn triggers the stimulation, which relies on tremor parameters-amplitude and frequency-derived from a pair of inertial sensors that record the kinematics of the affected joint. Surface electromyography also yields a first characterization of the tremor, together with precise information on the preferred stimulation site. Apart from allowing for an optimized performance of the system, our multimodal approach permits the implementation of redundant methods to both enhance the reliability of the system and adapt to the specific needs of different users. Results with a representative group of patients illustrate the performance of the interface presented here and demonstrate its feasibility.

Tremor constitutes the most common motor disorder, and poses a functional problem to a large number of patients. Despite of the considerable experience in tremor management, current treatment based on drugs or surgery does not attain an effective attenuation in 25 % of patients, motivating the need for research in new therapeutic alternatives. In this context, this paper presents the concept design, development, and preliminary validation of a soft wearable robot for tremor assessment and suppression. The TREMOR neurorobot comprises a Brain Neural Computer Interface that monitors the whole neuromusculoskeletal system, aiming at characterizing both voluntary movement and tremor, and a Functional Electrical Stimulation system that compensates for tremulous movements without impeding the user perform functional tasks. First results demonstrate the performance of the TREMOR neurorobot as a novel means of assessing and attenuating pathological tremors.