Multistatic radar is a promising option for the low-cost collection of multiple-Doppler weather observations. However, due to the use of low-directivity antennas at the receivers in these systems, they typically suffer from extremely high two-way sidelobe levels compared to monostatic radars. Doppler velocity estimation biases induced by sidelobe contamination have proved to be a significant obstacle to more widespread adoption of this technology. It has been noted in the existing literature that the technique of sidelobe whitening, first developed for use in monostatic systems, has the potential to mitigate this issue. However, the existing sidelobe whitening algorithm is not suitable for use in this application, as it is only capable of achieving whitening in the two-way antenna pattern, whereas an algorithm to be used in the multistatic case must be able to achieve this result in the transmit pattern alone. This article proposes an alternate sidelobe whitening technique based on the method of alternating projections which allows for effective whitening in the one-way antenna pattern. A multistatic weather radar time-series simulator is used in conjunction with numerical weather prediction data to demonstrate the effectiveness of this method in mitigating multiple-Doppler measurement biases.

Practical and accurate estimation of 3-D wind fields is an ongoing challenge in radar meteorology. Multistatic (single transmitter/multiple receivers) radar architectures offer a cost-effective solution for obtaining the multiple Doppler measurements necessary to achieve such estimates. Existing multistatic weather radars, while less costly than comparable monostatic networks, have been constrained by the need for specialized equipment and software to perform frequency and pulse timing synchronization with the transmitting radar. This article describes the implementation of a passive radar network that performs pulse timing and carrier frequency synchronization through measurements of the sidelobe radiation of the transmitting radar. This makes it possible for the receiver modules to be constructed with minimal size and cost, and it allows for their use in coordination with any in-band transmitter capable of recording time-stamped pointing angle information. A prototype network consisting of two passive receivers has been constructed in the Oklahoma City, OK, USA. Weather observations collected using the radiation from a WSR-88D have been used to validate the accuracy of velocity measurements obtained through this technique.

In an effort to study and characterize scattering mechanisms of debris particles in tornadoes, a numerical polarimetric radar emulator was developed. This paper is primarily motivated by attempts to explain radar observations near tornadoes. One such observation is the regions of negative differential reflectivity, which have been found near tornadoes but they are yet to be explained physically. There are hypotheses that suggest common debris alignment and/or dominant scattering from objects with high radar-cross-section (RCS) values that cause negative ZDR, but they are extremely challenging to verify due to the inherent danger near the vicinity of tornadoes. It is, however, possible to numerically construct the scenes through representative simulations to verify the plausible causes. This serves as our primary motivation to develop the radar emulator. The novel aspects of this paper are the realistic trajectory derivation, which is based on a physical air-drag model, and the representative diversity of RCS contributions from each debris object, developed through realistic polarimetric RCS modeling and anechoic chamber measurements.

Future weather radar systems will need to provide rapid updates within a flexible multifunctional overall radar network. This naturally leads to the use of electronically scanned phased array antennas. However, the traditional multifaced planar antenna approaches suffer from having radiation patterns that are variant in both beam shape and polarization as a function of electronic scan angle; even with practically challenging angle-dependent polarization correction, this places limitations on how accurately weather can be measured. A cylindrical array with commutated beams, on the other hand, can theoretically provide patterns that are invariant with respect to azimuth scanning with very pure polarizations. This paper summarizes recent measurements of the cylindrical polarimetric phased array radar demonstrator, a system designed to explore the benefits and limitations of a cylindrical array approach to these future weather radar applications.

Digital beamforming (DBF) has long been heralded as the next frontier in phased array technology, and not without reason. The digitization of transmit and receive signals at the element level opens the door to new processing and beamforming schemes and promises to deliver maximum flexibility and unprecedented dynamic range in large systems. However, it is not without inherent technological risks and practical challenges associated with the amount of data to process and the use of less sophisticated transceivers. This paper provides broad overviews of several interrelated aspects of the resulting DBF trade spaces for these systems. In particular, emerging concepts are highlighted for the roles and interconnection of distributed beamforming/processing for fixed and adaptive beamforming. These are then related to digital array calibration mechanisms that can potentially reduce the need for data- and processing-intensive beamforming algorithms.