This paper describes a novel clamping technology called compliant electroadhesion, as well as the first application of this technology to wall climbing robots. As the name implies, electroadhesion is an electrically controllable adhesion technology. It involves inducing electrostatic charges on a wall substrate using a power supply connected to compliant pads situated on the moving robot. High clamping forces (0.2-1.4 Newton supported by 1 square centimeter of clamp area, depending on substrate) have been demonstrated on a wide variety of common building substrates, both rough and smooth as well as both electrically conductive and insulating. Unlike conventional adhesives or dry adhesives, the electroadhesion can be modulated or turned off for mobility or cleaning. The technology uses a very small amount of power (on the order of 20 microwatts/Newton weight held) and shows the ability to repeatably clamp to wall substrates that are heavily covered in dust or other debris. Using this technology, SRI International has demonstrated a variety of wall climbing robots including tracked and legged robots.

Many new robotic and teleoperated applications require a high degree of mobility or dexterity that is difficult to achieve with current actuator technology. Natural muscle is an actuator that has many features, including high energy density, fast speed of response, and large stroke, that are desirable for such applications. The electrostriction of polymer dielectrics with compliant electrodes can be used in electrically controllable, muscle-like actuators. These electrostrictive polymer artificial muscle (EPAM) actuators can produce strains of up to 30% and pressures of up to 1.9 MPa. The measured specific energy achieved with polyurethane and silicone polymers exceeds that of electromagnetic, electrostatic, piezoelectric, and magnetostrictive actuators. A simple model using linear elastic theory can predict EPAM actuator performance from mechanical and electrical material properties and load conditions. A spherical joint for a highly articulated (snake-like) manipulator using EPAM actuator elements has been demonstrated. A rotary motor using EPAM actuator elements has been shown to produce a specific torque of 19 mNm/g and a specific power of 0.1 W/g. An improved EPAM motor could produce greater specific power and specific torque than could electric motors.

Because today's manipulators are generally limited to position-control functions and burdened by the excessive mass implicit in their machine-tool design assumptions, a novel design is proposed to overcome these limitations and lead to lighter, faster, and more useful robots. An elbow-manipulator design with highly geared motors is suggested in which the forelimb is made flexible in one plane, and is light in comparison to the loads. The compliant limb is located between kinematically redundant joints that can rotate the limb, thereby adjusting the manipulator end-point compliance. Nonlinear techniques can be used to augment vibration damping. Such a manipulator can carry out force-control and low-compliance tasks as well as conventional position-controlled functions.>