This work presents an extension of Karatsuba's method to efficiently use rectangular multipliers as a base for larger multipliers. The rectangular multipliers that motivate this work are the embedded 18 × 25-bit signed multipliers found in the DSP blocks of recent Xilinx FPGAs: The traditional Karatsuba approach must under-use them as square 18 × 18 ones. This work shows that rectangular multipliers can be efficiently exploited in a modified Karatsuba method if their input word sizes have a large greatest common divider. In the Xilinx FPG A case, this can be obtained by using the embedded multipliers as 16 × 24 unsigned and as 17 × 25 signed ones. The obtained architectures are implemented with due detail to architectural features such as the pre-adders and post-adders available in Xilinx DSP blocks. They are synthesized and compared with traditional Karatsuba, but also with (non-Karatsuba) state-of-the-art tiling techniques that make use of the full rectangular multipliers. The proposed technique improves resource consumption and performance for multipliers of numbers larger than 64 bits.

This work presents novel methods for the optimization of compressor trees for FPGAs as required in many arithmetic computations. As demonstrated in recent work, important key elements for the design of efficient but fast compressor trees are target-optimized 4:2 compressors as well as generalized parallel counters (GPCs). However, the optimization of a compressor tree for minimal resources using both compressors and GPCs has not been addressed so far. As this combined optimization is a non-trivial task, three methods are proposed to find best solutions for a given problem size: 1) a heuristic that obtains compressor trees with typically less resources and fewer stages than state-of-the-art heuristics, 2) an integer linear programming (ILP)-based methodology that finds optimal compressor trees using the fewest stages possible, 3) a combined approach that partially solves the problem heuristically to reduce the search space for the ILP-based method. In all methods, the cost for pipeline registers can be included. Synthesis experiments show that the proposed methods provide pipelined compressor trees with about 40 percent less LUTs compared to trees of 2-input adders at the cost of being about 12 ...20 percent slower.

This work presents a resource optimal approach for the design of large multipliers for FPGAs. These are composed of smaller multipliers which can be DSP blocks or logic-based multipliers. A previously proposed multiplier tiling methodology is used to describe feasible solutions of the problem. The problem is then formulated as an integer linear programming (ILP) problem which can be solved by standard ILP solvers. It can be used to minimize the total implementation cost or to trade the LUT cost against the DSP cost. It is demonstrated that although the problem is NP-complete, optimal solutions can be found for most practical multiplier sizes up to 64x64. Synthesis experiments on relevant multiplier sizes show slice reductions of up to 47.5% compared to state-of-the-art heuristic approaches.