Demonstration venue · read-only. Every page can be browsed; the buttons that would change it are switched off. Create an account to run TaxoReview on your own data. A simulation from public publication records: the people listed were not invited and did not agree to review.
? Tutorial for this page
Demo Data from SIGIR 2026 / reviewers in the wild / expert

G. J. Stiles

dblp:272/4483 · DBLP profile ↗
← Back
1ranked-venue papers
0as first author
0since 2021 · last 1975
—ORCID · none

Domains — the database's venue-derived domains; a paper can count in several

Computer networks · 1

Expertise — from the expertise taxonomy: the topics of the expert's papers under the CCF categories. A weight counts papers with recency: 1 for a paper about the topic, 0.3 when the topic is its context, halved every five years.

Computer networks
1 paper
Physical-layer communications · 100%

Topics — the 1 heaviest of 2, each with the papers that count most for it

TopicWeightPapersLastEvidence papers
Physical-layer communications › relaying › relay systems
regenerative repeaters		 0.011975
Determining Repeater Margin with a Stub and Attenuator · IEEE Trans. Commun. 1975

Methods — techniques the papers use, named apart from their topics

interference injection · 0.0error rate measurement · 0.0
YearPublicationVenuePosition
1975 Determining Repeater Margin with a Stub and Attenuator
abstract
The margin of a high-speed digital regenerative repeater can be determined easily by adding a misterminated stub at the repeater input. The stub adds an interfering signal which, if large enough, will cause the repeater to make errors. The amplitude of the interfering signal is determined by the termination, so the termination impedance at which errors begin is a good measure of repeater margin. No calibration procedure is required.
Virgil I. Johannes, G. J. Stiles
 IEEE Trans. Commun.2