This paper presents a wirelessly monitoring system for Total Hip Replacement (THR) surgery. This system aims to measure and display the attitude and position of femoral head of prosthetic implant during the surgery. The system consists of two parts: the Sensors Array Measuring System (SAMS) and the display part. The SAMS is composed of a sensors array, signal conditioning circuits, a low power Micro Control Unit (MCU), and a low-power transceiver. The SAMS is designed to measure the contact distribution of the sensors array (which is on the surface of the femoral head) between the surface of the femoral head and the acetabulum of the prosthesis. The data is transmitted wirelessly by a low power transceiver. The display part demonstrates the contact distribution and the attitude of the prothesis in-vivo in 3-D images. The two parts of the system communicate with each other on a RF link at the band of 400MHz. The signal conditioning circuits have been designed and fabricated in 0.18μm CMOS process. The tested results show that the resolution of the signal conditioning circuits is 60.1μVpp (1.35g) with ±100mVpp input and the chip can operate under 1.2V to 3.6V voltage supply for single battery application with 116-160μA power current consumption. The system has been validated by experimental results.

A low-power CMOS capacitance-to-digital converter for capacitive sensors array is presented. It consists of a 16-channel MUX, a front-end with wide dynamic range for capacitance-voltage conversion and a novel voltage-pulses convertor. This novel circuit charges the measured capacitor indirectly and converts it into a proportional voltage, and then produces a 16-bits pulses-formed single-line output with multi-steps quantization method. The circuit can operate under 1.2V to 3.6V voltage supply for single battery application. The maximum input is 350pF with 0.75ms/ch update rate and 90μA power consumption when the operating clock is 100KHz. The chip has been design and fabricated in 0.18-μm 1P6M CMOS process with active area of 640×630μm2.