This paper presents an aerial manipulator consisting of a multirotor equipped with a robotic multi-link arm attached to the top of the multirotor body. This setup has strong potentialities for inspection of structures, since the arm is able to safely touching the structure surface with a sensor while flying, taking measurements from the underside for example in bridges. The paper presents the dynamic model of the system and the derivation of a nonlinear controller, which is tested in simulation. First flight experiments with prototype of the system are also presented.

This paper presents the design and control of a multirotor-based aerial manipulator developed for outdoor operation. The multi-rotor has eight rotors and large payload to integrate a 7-degrees of freedom arm and to carry sensors and processing hardware needed for outdoor positioning. The arm can also carry an end-effector and sensors to perform different missions. The paper focuses on the control design and implementation aspects. A stable backstepping-based controller for the multirotor that uses the coupled full dynamic model is proposed, and an admittance controller for the manipulator arm is outlined. Several experimental tests with the aerial manipulator are also presented. In one of the experiments, the performance of the pitch attitude controller is compared to a PID controller. Other experiments of the arm controller following an object with the camera are also presented.

This paper deals with aerial manipulators consisting of an unmanned aerial vehicle equipped with a robotic multi-link arm. The paper presents methods for the control of the aerial platform taking into account the motion of the arm. It shows how a Variable Parameter Integral Backstepping controller outperforms the results obtained by using PID controllers. The paper presents a quadrotor with a new arm designed for assembly tasks and the implementation of the proposed control methods. Simulations and outdoor experiments confirm the validity of the proposed approach.