For the development of new 5G systems to operate in bands up to 100 GHz, there is a need for accurate radio propagation models at these bands that currently are not addressed by existing channel models developed for bands below 6 GHz. This document presents a preliminary overview of 5G channel models for bands up to 100 GHz. These have been derived based on extensive measurement and ray tracing results across a multitude of frequencies from 6 GHz to 100 GHz, and this document describes an initial 3D channel model which includes: 1) typical deployment scenarios for urban microcells (UMi) and urban macrocells (UMa), and 2) a baseline model for incorporating path loss, shadow fading, line of sight probability, penetration and blockage models for the typical scenarios. Various processing methodologies such as clustering and antenna decoupling algorithms are also presented.

This paper presents small-scale fading measurements for 28 GHz outdoor millimeter-wave ultrawideband channels using directional horn antennas at the transmitter and receiver. Power delay profiles were measured at half-wavelength spatial increments over a local area (33 wavelengths) on a linear track in two orthogonal receiver directions in a typical base-to-mobile scenario with fixed transmitter and receiver antenna beam pointing directions. The voltage path amplitudes are shown to follow a Rician distribution, with K-factor ranging from 9 - 15 dB and 5 - 8 dB in line of sight (LOS) and non-line of sight (NLOS) for a vertical-to-vertical co- polarized antenna scenario, respectively, and from 3 - 7 dB in both LOS and NLOS vertical-to- horizontal cross-polarized antenna scenario. The average spatial autocorrelation functions of individual multipath components reveal that signal amplitudes reach a correlation of 0 after 2 and 5 wavelengths in LOS and NLOS co-polarized V-V antenna scenarios. The models provided are useful for recreating path gain statistics of millimeter- wave wideband channel impulse responses over local areas, for the study of multi-element antenna simulations and channel estimation algorithms.

Omnidirectional path loss models are vital for radiosystem design in wireless communication systems, as they allow engineers to perform network simulations for systems with arbitrary antenna patterns. At millimeter-wave frequencies, channel measurements are frequently conducted using steerable highgain directional antennas at both the transmitter and receiver to make up for the significant increase in free space path loss at these frequencies compared to traditional cellular systems that operate at lower frequencies. The omnidirectional antenna pattern, and resulting omnidirectional received power must therefore be synthesized from many unique pointing angles, where the transmit and receive antennas are rotated over many different azimuth and elevation planes. In this paper, the equivalent omnidirectional antenna pattern and omnidirectional received power are synthesized by summing the received powers from all measured unique pointing angles obtained at antenna halfpower beamwidth step increments in the azimuth and elevation planes, and this method is validated by demonstrating that the synthesized omnidirectional received power and path loss are independent of antenna beamwidth, through theoretical analyses and millimeter-wave propagation measurements using antennas with different beamwidths. The method in this paper is shown to provide accurate results while enhancing the measurement range substantially through the use of directional antennas.

This paper presents directional and omnidirectional RMS delay spread statistics obtained from 28 GHz and 73 GHz ultrawideband propagation measurements carried out in New York City using a 400 Megachips per second broadband sliding correlator channel sounder and highly directional steerable horn antennas. The 28 GHz measurements did not systematically seek the optimum antenna pointing angles and resulted in 33% outage for 39 T-R separation distances within 200 m. The 73 GHz measurements systematically found the best antenna pointing angles and resulted in 14.3% outage for 35 T-R separation distances within 200 m, all for mobile height receivers. Pointing the antennas to yield the strongest received power is shown to significantly reduce RMS delay spreads in line-of-sight (LOS) environments. A new term, distance extension exponent (DEE) is defined, and used to mathematically describe the increase in coverage distance that results by combining beams from angles with the strongest received power at a given location. These results suggest that employing directionality in millimeter-wave communications systems will reduce inter-symbol interference, improve link margin at cell edges, and enhance overall system performance.

This paper presents an omnidirectional spatial and temporal 3-dimensional statistical channel model for 28 GHz dense urban non-line of sight environments. The channel model is developed from 28 GHz ultrawideband propagation measurements obtained with a 400 megachips per second broadband sliding correlator channel sounder and highly directional, steerable horn antennas in New York City. A 3GPP-like statistical channel model that is easy to implement in software or hardware is developed from measured power delay profiles and a synthesized method for providing absolute propagation delays recovered from 3-D ray-tracing, as well as measured angle of departure and angle of arrival power spectra. The extracted statistics are used to implement a MATLAB-based statistical simulator that generates 3-D millimeter-wave temporal and spatial channel coefficients that reproduce realistic impulse responses of measured urban channels. The methods and model presented here can be used for millimeter-wave system-wide simulations, and air interface design and capacity analyses.

Next-generation wireless communications systems are expected to exploit frequency bands above 6 GHz. An important transition towards such bands will be design of channel models capable of supporting the design of efficient air-interface and networks. In this paper, we describe a geometry-based statistical channel model and apply ray-tracing simulation for its validation. Focusing on path loss and root-mean-square (RMS) delay spread as metrics, we show that the proposed modeling approach is flexible and realistic.

The relatively unused millimeter-wave (mmWave) spectrum offers excellent opportunities to increase mobile capacity due to the enormous amount of available raw bandwidth. This paper presents experimental measurements and empirically-based propagation channel models for the 28, 38, 60, and 73 GHz mmWave bands, using a wideband sliding correlator channel sounder with steerable directional horn antennas at both the transmitter and receiver from 2011 to 2013. More than 15,000 power delay profiles were measured across the mmWave bands to yield directional and omnidirectional path loss models, temporal and spatial channel models, and outage probabilities. Models presented here offer side-by-side comparisons of propagation characteristics over a wide range of mmWave bands, and the results and models are useful for the research and standardization process of future mmWave systems. Directional and omnidirectional path loss models with respect to a 1 m close-in free space reference distance over a wide range of mmWave frequencies and scenarios using directional antennas in real-world environments are provided herein, and are shown to simplify mmWave path loss models, while allowing researchers to globally compare and standardize path loss parameters for emerging mmWave wireless networks. A new channel impulse response modeling framework, shown to agree with extensive mmWave measurements over several bands, is presented for use in link-layer simulations, using the observed fact that spatial lobes contain multipath energy that arrives at many different propagation time intervals. The results presented here may assist researchers in analyzing and simulating the performance of next-generation mmWave wireless networks that will rely on adaptive antennas and multiple-input and multiple-output (MIMO) antenna systems.

This paper presents ultra-wideband statistical spatial and omnidirectional channel models for 28 GHz millimeter-wave cellular dense urban Non-Line of Sight (NLOS) environments, developed from wideband measurements in New York City that used synthesized timing from 3D ray-tracing. An accurate 3GPP-like channel model has been developed, where model parameters are based on empirical distributions for time cluster and spatial (lobe) channel parameters. A statistical simulator capable of reproducing the joint temporal and spatial measured channel statistics is given here. A step-by-step procedure for generating channel coefficients is shown to validate measured statistics from 28 GHz field measurements, thus validating our statistical channel model, for use in standard bodies and system-level simulations for millimeter-wave wideband communications.

The performance of multi-beam antenna equal gain combining for improving signal quality in future millimeter-wave cellular systems is evaluated in this article. Employing experimental data obtained from 28 GHz and 73 GHz propagation measurements in the dense urban environment of New York City, we present the impact of coherent bi-beam, tri-beam and quad-beam combining on path loss and shadow factors. The results reveal that a maximum of 24.9 dB improvement in path loss at 28 GHz and 34.8 dB at 73 GHz for 100 m T-R (transmitter-receiver) separation distances can be achieved via combining the strongest four received signals from distinct beams, when compared to the case of signals at the receiver with randomly pointed beams. Comparable path loss values are achieved at both 28 and 73 GHz bands. This paper demonstrates the potential of utilizing spatial filtering and beam combining to significantly improve received signal levels and link margins at millimeter-wave frequencies.

This paper presents newly generated omnidirectional close-in free space reference distance and floating intercept path loss models obtained from 28 GHz and 73 GHz RF ultrawideband propagation measurements collected in Downtown Manhattan using a 400 Mega-chip-per-second sliding correlator channel sounder. Simplified path loss models with respect to a 1 m close-in free space reference distance are provided here for the omnidirectional propagation models, and are suitable for system-wide simulations similar to 3GPP and WINNER II. Measured path loss exponents at millimeter-wave and current UHF/Microwave cellular frequencies are very similar. The significant difference in large-scale path loss between UHF and millimeter-wave channels is the extra free space attenuation due to the increase in carrier frequency.

Massive MIMO systems are well-suited for mm-Wave communications, as large arrays can be built with reasonable form factors, and the high array gains enable reasonable coverage even for outdoor communications. One of the main obstacles for using such systems in frequency-division duplex mode, namely, the high overhead for the feedback of channel state information (CSI) to the transmitter, can be mitigated by the recently proposed joint spatial division and multiplexing (JSDM) algorithm. In this paper, we analyze the performance of this algorithm in somerealisticpropagation channels that take into account the partial overlap of the angular spectra from different users, as well as the sparsity of mm-Wave channels. We formulate the problem of user grouping for two different objectives, namely, maximizing spatial multiplexing and maximizing total received power in a graph-theoretic framework. As the resulting problems are numerically difficult, we proposed (sub optimum) greedy algorithms as efficient solution methods. Numerical examples show that the different algorithms may be superior in different settings. We furthermore develop a new, “degenerate” version of JSDM that only requires average CSI at the transmitter and thus greatly reduces the computational burden. Evaluations in propagation channels obtained from ray tracing results, as well as inmeasuredoutdoor channels, show that this low-complexity version performs surprisingly well in mm-Wave channels.

With the severe spectrum shortage in conventional cellular bands, millimeter wave (mmW) frequencies between 30 and 300 GHz have been attracting growing attention as a possible candidate for next-generation micro- and picocellular wireless networks. The mmW bands offer orders of magnitude greater spectrum than current cellular allocations and enable very high-dimensional antenna arrays for further gains via beamforming and spatial multiplexing. This paper uses recent real-world measurements at 28 and 73 GHz in New York, NY, USA, to derive detailed spatial statistical models of the channels and uses these models to provide a realistic assessment of mmW micro- and picocellular networks in a dense urban deployment. Statistical models are derived for key channel parameters, including the path loss, number of spatial clusters, angular dispersion, and outage. It is found that, even in highly non-line-of-sight environments, strong signals can be detected 100-200 m from potential cell sites, potentially with multiple clusters to support spatial multiplexing. Moreover, a system simulation based on the models predicts that mmW systems can offer an order of magnitude increase in capacity over current state-of-the-art 4G cellular networks with no increase in cell density from current urban deployments.

In this paper, we present reflection coefficients and penetration losses for common building materials at 28 GHz for the design and deployment of future millimeter wave mobile communication networks. Reflections from walls and buildings and penetration losses were measured for indoor and outdoor materials, such as tinted glass, clear glass, brick, concrete, and drywall at 28 GHz in New York City. A 400 Mega-chip-per-second sliding correlator channel sounder and 24.5 dBi steerable horn antennas were used to emulate future mobile devices with adaptive antennas that will likely be used in future millimeter wave cellular systems [1]. Measurements in and around buildings show that outdoor building materials are excellent reflectors with the largest measured reflection coefficient of 0.896 for tinted glass as compared to indoor building materials that are less reflective. We also found that penetration loss is dependent not only on the number of obstructions and distance between transmitter and receiver, but also on the surrounding environment. The greatest penetration loss containing three interior walls of an office building was found to be 45.1 dB, with 11.39 m separation between the transmitter and receiver.

Propagation measurements at 28 GHz were conducted in outdoor urban environments in New York City using four different transmitter locations and 83 receiver locations with distances of up to 500 m. A 400 mega- chip per second channel sounder with steerable 24.5 dBi horn antennas at the transmitter and receiver was used to measure the angular distributions of received multipath power over a wide range of propagation distances and urban settings. Measurements were also made to study the small-scale fading of closely-spaced power delay profiles recorded at half-wavelength (5.35 mm) increments along a small-scale linear track (10 wavelengths, or 107 mm) at two different receiver locations. Our measurements indicate that power levels for small- scale fading do not significantly fluctuate from the mean power level at a fixed angle of arrival. We propose here a new lobe modeling technique that can be used to create a statistical channel model for lobe path loss and shadow fading, and we provide many model statistics as a function of transmitter- receiver separation distance. Our work shows that New York City is a multipath-rich environment when using highly directional steerable horn antennas, and that an average of 2.5 signal lobes exists at any receiver location, where each lobe has an average total angle spread of 40.3° and an RMS angle spread of 7.8°. This work aims to create a 28 GHz statistical spatial channel model for future 5G cellular networks.