The boil-turbine system is a multivariable and strong coupling system with the characteristics of nonlinearity, time-varying parameters, and large delay. The accurate model can effectively improve the performance of turbine–boiler coordinated control system. In this paper, the boil-turbine model is established by interval type-2 (IT2) T-S fuzzy model. The premise parameters of IT2 T-S fuzzy model are identified by robust IT2 fuzzy c-regression model (RIT2-FCRM) clustering algorithm. The RIT2-FCRM is based on interval type-2 fuzzy sets (IT2FS) and applies a robust objective function, this clustering algorithm can reduce the impacts of outliers and noise points. The effectiveness and practicability of RIT2-FCRM are demonstrated by the identification results of the boiler–turbine system.

Bed temperature in dense-phase zone is the key parameter of circulating fluidized bed (CFB) boiler for stable combustion and economic operation. It is difficult to establish an accurate bed temperature model as the complexity of circulating fluidized bed combustion system. T-S fuzzy model was widely applied in the system identification for it can approximate complex nonlinear system with high accuracy. Fuzzy c-regression model (FCRM) clustering based on hyper-plane-shaped distance has the advantages in describing T-S fuzzy model, and Gaussian function was adapted in antecedent membership function of T-S fuzzy model. However, Gaussian fuzzy membership function was more suitable for clustering algorithm using point to point distance, such as fuzzy c-means (FCM). In this paper, a hyper-plane-shaped FCRM clustering algorithm for T-S fuzzy model identification algorithm is proposed. The antecedent membership function of proposed identification algorithm is defined by a hyper-plane-shaped membership function and an improved fuzzy partition method is applied. To illustrate the efficiency of the proposed identification algorithm, the algorithm is applied in four nonlinear systems which shows higher identification accuracy and simplified identification process. At last, the algorithm is used in a circulating fluidized bed boiler bed temperature identification process, and gets better identification result.

Increasing design densities on large FPGAs and greater demand for performance, has calledfor special purpose tools like floorplanner, performance driven router, and more. In this paper we present a floorplanning based design mapping solution that is capable of mapping macro cell based designs as well as hierarchicaldesigns on FPGAs. The mapping solution has been tested extensively on a large collection of designs. We not only outperform state of the art CAE tools from industry in terms of execution time but also achieve much better performance in terms of timing. These methods are especially suitable for mapping designs on very large FPGAs.