Visible light communication (VLC) provides a short- range optical wireless communication through light- emitting diode (LED) lighting. Light beam flickering and dimming are among the challenges to be addressed in VLC. Conventional methods for generating flicker-free codes in VLC are based on run-length limited codes that have poor error correction performance, use lookup tables which are memory consuming, and have low transmission rates. In this paper, we propose an efficient construction of flicker-free forward error correction codes to tackle the issue of flickering in VLC. Our simulation results show that by using polar codes and at a dimming ratio of 50%, the proposed system generates flicker-free codes without using lookup tables, while having lower complexity and higher transmission rates than the standard VLC methods. For an information block length of 256, the error correction performance of the proposed scheme is 1.8 dB and 0.9 dB better than that of the regular schemes at the bit error rate of 10^{-6} for a rate of 0.44 and 0.23, respectively.

Polar codes are the first class of error correcting codes that provably achieve the channel capacity at infinite code length. They were selected for use in the fifth generation of cellular mobile communications (5G). In practical scenarios such as 5G, a cyclic redundancy check (CRC) is concatenated with polar codes to improve their finite length performance. This is mostly beneficial for sequential successive-cancellation list decoders. However, for parallel iterative belief propagation (BP) decoders, CRC is only used as an early stopping criterion with incremental error-correction performance improvement. In this paper, we first propose a CRC-polar BP (CPBP) decoder by exchanging the extrinsic information between the factor graph of the polar code and that of the CRC. We then propose a neural CPBP (NCPBP) algorithm which improves the CPBP decoder by introducing trainable normalizing weights on the concatenated factor graph. Our results on a 5G polar code of length 128 show that at the frame error rate of 10-5and with a maximum of 30 iterations, the error-correction performance of CPBP and NCPBP are approximately 0.25 dB and 0.5 dB better than that of the conventional CRC-aided BP decoder, respectively, while introducing almost no latency overhead.

We introduce a new construction for the balancing of non-binary sequences that make use of Gray codes for prefix coding. Our construction provides full encoding and decoding of sequences, including the prefix. This construction is based on a generalization of Knuth's parallel balancing approach, which can handle very long information sequences. However, the overall sequence-composed of the information sequence, together with the prefix-must be balanced. This is reminiscent of Knuth's serial algorithm. The encoding of our construction does not make use of lookup tables, while the decoding process is simple and can be done in parallel.

We present an encoding and decoding scheme for constant weight sequences, that is, given an information sequence, the construction results in a sequence of specific weight within a certain range. The scheme uses a prefix design that is based on Gray codes. Furthermore, by adding redundant symbols we extend the range of weight values for output sequences, which is useful for some applications.

Balancing sequences over a non-binary alphabet is considered, where the algebraic sum of the components (also known as the weight) is equal to some specific value. Various schemes based on Knuth's simple binary balancing algorithm have been proposed. However, these have mostly assumed that the prefix describing the balancing point in the algorithm can easily be encoded. In this paper we show how non-binary Gray codes can be used to generate these prefixes. Together with a non-binary balancing algorithm, this forms a complete balancing system with straightforward and efficient encoding/decoding.