This paper considers the fundamental power allocation problem in cell-free massive mutiple-input and multiple-output (MIMO) systems which aims at maximizing the total energy efficiency (EE) under a sum power constraint at each access point (AP) and a quality-of-service (QoS) constraint at each user. Existing solutions for this optimization problem are based on solving a sequence of second-order cone programs (SOCPs), whose computational complexity scales dramatically with the network size. Therefore, they are not implementable for practical large-scale cell-free massive MIMO systems. To tackle this issue, we propose an iterative power control algorithm based on the frame work of an accelerated projected gradient (APG) method. In particular, each iteration of the proposed method is done by simple closed-form expressions, where a penalty method is applied to bring constraints into the objective in the form of penalty functions. Finally, the convergence of the proposed algorithm is analytically proved and numerically compared to the known solution based on SOCP. Simulations results demonstrate that our proposed power control algorithm can achieve the same EE as the existing SOCPs-based method, but more importantly, its run time is much lower (one to two orders of magnitude reduction in run time, compared to the SOCPs-based approaches).

Cell-free massive multiple-input multiple-output (MIMO) system is a promising architecture for next generation wireless systems by deploying a very large number of distributed access points (APs), which simultaneously serve a smaller number of user equipments (UEs) over the same time-frequency resources. It guarantees uniformly good service at high spectral efficiency with simple linear precoding techniques and max-min power control. In this article, we propose a new joint maximum-ratio and zero-forcing (JMRZF) precoding scheme, where part of APs are combined to perform centralized zero-forcing (ZF), while other APs apply simple maximum-ratio transmission (MRT). Our proposed precoder offers an adaptable trade-off between the spectral efficiency and front-haul signalling overhead. A corresponding AP subset selection scheme is also proposed which is based on large-scale fading coefficients. A closed-form expression for the achievable spectral efficiency of our proposed scheme is derived, which represents a generalized result including both fully distributed MRT and fully centralized ZF cases. Based on this closed-form expression, max-min power control is formulated and solved via the second order cone and first order methods. The former can obtain the global optimal solution, but its computational complexity is very high. On the other hand, the latter technique is sub-optimal, yet, it has very low computational complexity. Hence, it is suitable for large-scale cell-free massive MIMO systems with hundreds or thousands of APs and users. Numerical results show that our proposed JMRZF scheme can substantially outperform the local precoding schemes, even when a small part of APs are combined to deploy ZF and is implementable even when each AP has very few antennas. In addition, it is shown that our max-min power controls improves the spectral efficiency significantly, compared to the uniform power control scheme.

This paper studies a cell-free massive multiple-input multiple-output (MIMO) system where its access points (APs) and users are equipped with multiple antennas. Two transmission protocols are considered. In the first transmission protocol, there are no downlink pilots, while in the second transmission protocol, downlink pilots are proposed in order to improve the system performance. In both transmission protocols, the users use the minimum mean-squared error-based successive interference cancellation (MMSE-SIC) scheme to detect the desired signals. For the analysis, we first derive a general spectral efficiency formula with arbitrary side information at the users. Then analytical expressions for the spectral efficiency of different transmission protocols are derived. To improve the spectral efficiency (SE) of the system, max-min fairness power control (PC) is applied for the first protocol by using the closed-form expression of its SE. Due to the computation complexity of deriving the closed-form performance expression of SE for the second protocol, we apply the optimal power coefficients of the first protocol to the second protocol. Numerical results show that two protocols combining with multi-antenna users are prerequisites to achieve the sub-optimal SE regardless of the number of user in the system.

A key challenge in nanonetworking is to develop a means of coordinating a large number of nanoscale devices. Molecular communication has emerged as a promising technique to assist in the coordination problem. Devices in molecular communication systems-once information molecules are released-are typically viewed as passive, not reacting chemically with the information molecules. While this is an accurate model in diffusion-limited links, it is not the only scenario. In particular, the dynamics of molecular communication systems are more generally governed by reaction-diffusion, where the reaction dynamics can also dominate. This leads to the notion of reaction-limited molecular communication systems, where the concentration profiles of information molecules and other chemical species depends largely on reaction kinetics. In this regime, the system can be approximated by a chemical reaction network. In this paper, we exploit this observation to design new protocols for both point-to-point links with feedback and networks for event detection. In particular, using connections between consensus and advection theory and reaction networks lead to simple characterizations of equilibrium concentrations, which yield simple-but accurate-design rules even for networks with a large number of devices.

We consider a diffusion-based nano-network with N spatially distributed transmitters and one receiver. While the transmitters are linked in a unified entity to perform one transmission, the receiver is large enough to be viewed as a plane. Messages are encoded into the number of nano-scale molecules. Based on these assumptions, we analyze the signal-to-interference ratio, which is based on the average numbers of absorbed molecules. Moreover, we present an approach to interference alignment for molecular communications.