This paper proposes a novel integrated multiport bidirectional back-to-back power converter for a type-4 wind turbine that accommodates a battery and supercapacitor for energy storage. The circuit topology reduces 4 switches compared to the traditional configuration. Moreover, owing to the dual-buck structure embedded in the phase leg, the circuitry has no short-circuit path, therefore it withstands short-circuited events for a much longer time than the normal phase-leg and prevents the reverse current in turn-off recovery. The use of a hybrid energy storage system with battery and supercapacitor helps smooth out the power output under wind gusts and stabilizes the DC-link voltage under grid fault conditions. The case studies are carried out with a 1.5 MW wind turbine system. Simulation results are provided for the theoretical validation.

This paper proposes a novel integrated multiport bidirectional dc-dc converter to interface the battery, the ultra-capacitor, the fuel cell, or other energy sources with the dc-link capacitor of the hybrid energy systems such as the hybrid electric vehicle (HEV) and fuel cell vehicle (FCV) applications. The proposed converter can be applied to the distributed generation systems which include local energy sources, storage, and loads. It can perform both buck and boost functions with fewer switches. In addition, it is extendable when more inputs and/or outputs are required. The operating principle and control strategy of the proposed converter will be analyzed in detail. For verification, simulation, and experimental results of the four utilized operating modes of an HEV/FCV are provided.

Hydrogen electrolyzers, with their operational flexibility, can be configured as smart dynamic loads which can provide grid services and facilitate the integration of more renewable energy sources into the electrical grid. However, to enable this ability, the electrolyzer system should be able to control both active and reactive power in coordination with the low-level controller of the electrolyzer via the power electronics system interface between the utility grid and electrolyzer. This paper discusses power converter topologies and the control scheme of this power electronics interface for electrolyzer applications to enable electricity grid services. For the sake of unity, in this paper, we consider the power converter system interfacing the utility grid at the line-to-line root mean square (RMS) value of 480 VAC-60 Hz and supplying to the 3500 A-750 kW PEM electrolyzer stack.