Machines tend to use powerful actuators and large gearboxes to bear large loads, which are inconvenient in terms of responsiveness as they affect the duration of operations. Thus, to compensate the force to grasp an object, we propose a clamping mechanism implementing the internally-balanced magnetic unit (IB Magnet) as a force amplifier, which is a mechanism able to switch attached and detached states of a permanent magnet with an external force considerably smaller than its original attractive force. To realize the bi-parting constitution of fingers, a new compensation method using conical coil springs was designed to provide both precision and miniaturization. Relative to the constitution with a single motored screw, the prototype gripper for proof of concept successfully amplified the grasping force at most to 292.2% assisted by the magnetic attraction, while keeping the increase in power consumption of a DC motor only by 11.8%, making the force-energy efficiency 2.6 times larger. Thus, it was verified that the proposed gripper enables the use of actuators and current supplies that require less power.

To detach a permanent magnet using a control force much smaller than its original attractive force, the internally-balanced magnetic unit (IB Magnet) was invented. It has been applied to magnetic devices such as wall-climbing robots, ceiling-dangling drones, and modular swarm robots. In contrast to its significant reduction rate with regard to the control force, the IB Magnet has two major problems in its nonlinear spring, which serves the purpose of cancelling out the internal force on the magnet. These problems include the complicated design procedure and the trade-off relationship between balancing the precision and the volume of the mechanism. This paper proposes a principle for a new balancing method for the IB Magnet. This method uses a like-pole pair of magnets as a magnetic spring, whose repulsive force should equal the attractive force of an unlike-pole pair. To verify the proposed principle, a prototype of the IB Magnet was designed using a magnetic spring and verified through experiments such that its reduction rate is comparable to those of conventional IB Magnets. Moreover, a robotic clamp was developed as an application example that contains the proposed IB Magnets as its internal mechanism.

We introduced the disturbance degree of ground and proposed an evaluation method to measure the mobile performance of a crawler on soft ground during direction switching. First, we developed a planar omnidirectional crawler, which had a configuration with two left and right unit crawlers for performing turning motion, as the target for evaluation. Second, by utilizing the proposed disturbance degree of ground evaluation method, we investigated how the turning and translational motions of the crawler mechanism affected soft ground by measuring the flow of sand on a horizontal surface. It was quantitatively shown that translational motion switched the travel direction with lesser disturbance to the road surface compared to turning motion. We confirmed that ground disturbance could be evaluated during direction switching using the proposed method.