In FinFET nodes, high transistor power densities in a power amplifier (PA) lead to device self-heating (SH), degrading performance. This study investigates the impact of SH in large PA FinFET arrays. An encoder-decoder network, together with a long short-term memory model, is used for rapid and accurate thermal analysis. This fast analyzer helps better explore design optimizations than conventional computationally-expensive thermal solvers. The work explores methods for mitigating thermal effects in PAs by inserting dummy transistors within the array of active FinFET devices, and shows the impact of duty cycle and frequency on PA performance.

This paper describes an unconventional way to apply wireless networking in emerging technologies. It makes the case for using a two-tier hybrid wireless/wired architecture to interconnect hundreds to thousands of cores in chip multiprocessors (CMPs), where current interconnect technologies face severe scaling limitations in excessive latency, long wiring, and complex layout. We propose a recursive wireless interconnect structure called the WCube that features a single transmit antenna and multiple receive antennas at each micro wireless router and offers scalable performance in terms of latency and connectivity. We show the feasibility to build miniature on-chip antennas, and simple transmitters and receivers that operate at 100 − 500 GHz sub-terahertz frequency bands. We also devise new two-tier wormhole based routing algorithms that are deadlock free and ensure a minimum-latency route on a 1000core on-chip interconnect network. Our simulations show that our protocol suite can reduce the observed latency by 20 % to 45%, and consumes power that is comparable to or less than current 2-D wiredmeshdesigns.

In this paper, we explore the use of multi-band radio frequency interconnect (or RF-I) with signal propagation at the speed of light to provide shortcuts in a many core network-on-chip (NoC) mesh topology. We investigate the costs associated with this technology, and examine the latency and bandwidth benefits that it can provide. Assuming a 400mm2die, we demonstrate that in exchange for 0.13% of area overhead on the active layer, RF-I can provide an average 13% (max 18%) boost in application performance, corresponding to an average 22% (max 24%) reduction in packet latency. We observe that RF access points may become traffic bottlenecks when many packets try to use the RF at once, and conclude by proposing strategies that adapt RF-I utilization at runtime to actively combat this congestion.

In this paper, we propose a new way of implementing on-chip global interconnect that would meet stringent challenges of core-to-core communications in latency, data rate, and re-configurability for future chip-microprocessors (CMP) with efficient area and energy overheads. We discuss the limitation of traditional RC-limited interconnects and possible benefits of multi-band RF-interconnect (RF-I) through on-chip differential transmission lines. The physical implementation of RF-I and its projected performance versus overhead as the function of CMOS technology scaling are discussed as well

As chip multiprocessors scale to a greater number of processing cores, on-chip interconnection networks will experience dramatic increases in both bandwidth demand and power dissipation. Fortunately, promising gains can be realized via integration of radio frequency interconnect (RF-I) through on-chip transmission lines with traditional interconnects implemented with RC wires. While prior work has considered the latency advantage of RF-I, we demonstrate three further advantages of RF-I: (1) RF-I bandwidth can be flexibly allocated to provide an adaptive NoC, (2) RF-I can enable a dramatic power and area reduction by simplification of NoC topology, and (3) RF-I provides natural and efficient support for multicast. In this paper, we propose a novel interconnect design, exploiting dynamic RF-I bandwidth allocation to realize a reconfigurable network-on-chip architecture. We find that our adaptive RF-I architecture on top of a mesh with 4B links can even outperform the baseline with 16B mesh links by about 1%, and reduces NoC power by approximately 65% including the overhead incurred for supporting RF-I.