We present NeWRF, a novel deep-learning-based framework for predicting wireless channels. Wireless channel prediction is a long-standing problem in the wireless community and is a key technology for improving the coverage of wireless network deployments. Today, a wireless deployment is evaluated by a site survey which is a cumbersome process requiring an experienced engineer to perform extensive channel measurements. To reduce the cost of site surveys, we develop NeWRF, which is based on recent advances in Neural Radiance Fields (NeRF). NeWRF trains a neural network model with a sparse set of channel measurements, and predicts the wireless channel accurately at any location in the site. We introduce a series of techniques that integrate wireless propagation properties into the NeRF framework to account for the fundamental differences between the behavior of light and wireless signals. We conduct extensive evaluations of our framework and show that our approach can accurately predict channels at unvisited locations with significantly lower measurement density than prior state-of-the-art.

WiFi communication should be possible only between devices inside the same network. However, we find that all existing WiFi devices send back acknowledgments (ACKs) to even fake packets received from unauthorized WiFi devices outside of their network. Moreover, we find that an unauthorized device can manipulate the power-saving mechanism of WiFi radios and keep them continuously awake by sending specific fake beacon frames to them. Our evaluation of over 5000 devices from 186 vendors confirms that these are widespread issues. We believe these loopholes cannot be prevented, and hence they create privacy and security concerns. Finally, to show the importance of these issues and their consequences, we implement and demonstrate two attacks where an adversary performs battery drain and WiFi sensing attacks just using a tiny WiFi module which costs less than ten dollars.

Millimeter wave (mmWave) technology enables wireless devices to communicate using very high-frequency signals. Operating at those frequencies provides larger bandwidth which can be used to enable high-data-rate links, and very accurate localization of devices. However, radios operating at high-frequencies consume significant amount of power, making them unsuitable for applications with limited energy sources. This paper presents MilBack, a backscatter network operating at mmWave bands. Backscattering is the most energy-efficient wireless communication technique, where nodes piggyback their data on an access point's signal instead of generating their own signals. Eliminating the need for signal generation significantly reduces the energy-consumption of the nodes. In contrast to past mmWave backscatter work which supports only uplink, MilBack is the first mmWave backscatter network which supports uplink, downlink, and accurate localization. MilBack addresses the key challenges that prevent existing backscatter networks to enable both uplink and downlink at mmWave bands. We implemented MilBack and evaluated its performance empirically. Our results show that MilBack is capable of achieving accurate localization, uplink, and downlink communication at up to 8 m while consuming only 32 mW and 18 mW, respectively.

Recent years have seen significant advances in WiFi Localization. However, existing systems require either multiple access points to cooperate with each other or a single access point to have multiple antennas and transceiver chains. Therefore, they cannot be integrated into most IoT WiFi chipsets which have only a single transceiver chain. This paper presents WiSight, a novel approach to bringing WiFi localization to any WiFi devices, especially those with a single RF chain. We propose a WiFi antenna design and use the inherent properties of the 802.11 protocol to measure Angle-of-Arrival (AoA) and Time-of-Flight (ToF) using a single transceiver chain. Our proof-of-concept simulation and real world experiments promise the feasibility of this approach.