The structure and behavior of the electrical double-layer capacitor (EDLC) are described. The use of activated carbon electrodes is discussed and the limitations on voltage and accessible surface area are presented. Metrics for evaluating EDLC performance are defined and previously reported results of experimental carbon nanotube (CNT) electrodes are tabulated. New experimental results of electrodes constructed of vertically aligned CNTs grown on a conducting substrate are presented. By extrapolating prior and new experimental data the energy density of CNT-based EDLCs is shown to be potentially up to seven times that of commercial activated carbon-based EDLCs.

This paper proposes a fault coverage model for linear time-invariant (LTI) systems subject to uncertain input. A state-space representation, defined by the state-transition matrix, and the input matrix, is used to represent LTI system dynamic behavior. The uncertain input is considered to be unknown but bounded, where the bound is defined by an ellipsoid. The state-transition matrix, and the input matrix must be such that, for any possible input, the system dynamics meets its intended function, which can be defined by some performance requirements. These performance requirements constrain the system trajectories to some region of the state-space defined by a symmetrical polytope. When a fault occurs, the state-transition matrix, and the input matrix might be altered; and then, it is guaranteed the system survives the fault if all possible post-fault trajectories are fully contained in the region of the state-space defined by the performance requirements. This notion of guaranteed survivability is the basis to model (in the context of LTI systems) the concept of fault coverage, which is a probabilistic measure of the ability of the system to keep delivering its intended function after a fault. Analytical techniques to obtain estimates of the proposed fault coverage model are presented. To illustrate the application of the proposed model, two examples are discussed.

The technical challenges of developing very-high-power-density power supplies operating of switching frequencies in the vicinity of 10 MHz are considered. Primary applications are in the computer, telecommunications, and automotive industries. It is shown that a successful development requires simultaneous considerations of topologies, materials, devices, control, electromagnetic interference, manufacturing, and packaging. Some results of work being done at MIT are presented, including a new integrated power MOSFET/driver, high-field frequency magnetic material characterizations, and high-frequency synchronous rectifiers. The design and performance of a 50-W 3.5-MHz converter is described.>