This paper presents the design of a 14 degree-of-motion forearm actuation unit for an upper extremity prosthesis. The forearm utilizes pneumatic type actuators which use the reaction products of a monopropellant gas generator as a working fluid. The use of pneumatic type actuators provides a near-human power density, such that the fourteen actuator forearm unit can deliver approximately one half of the force and power capability of a human arm, with a total package size that fits within the volumetric constraints of a 50thpercentile female forearm (excluding the cartridge of liquid propellant). This paper describes the design of the forearm. The design has been fabricated, and experimental results are presented that demonstrate the closed-loop force tracking capability. An accompanying video further demonstrates the forearm performance.

This paper presents the design of a gas-actuated anthropomorphic arm prosthesis with 21 degrees of freedom and nine independent actuators. The prosthesis utilizes the monopropellant hydrogen peroxide as a gas generator to power nine pneumatic type actuators. Of the nine independent actuators, one provides direct- drive actuation of the elbow, three provide direct-drive actuation for the wrist, and the remaining five actuate an underactuated 17 degree of freedom hand. This paper describes the design of the prosthesis, including the design of small-scale high-performance servovalves, which enable the implementation of the monopropellant concept in a transhumeral prosthesis. Experimental results are given characterizing both the servovalve performance and the force and/or motion control of various joints under closed-loop control.

The stable simulation of high-stiffness surfaces remains a challenge in impedance-type haptic simulations of mechanical environments. In this paper, the authors propose an approach to achieving a stable, high-stiffness surface in a haptic interface by leveraging the open-loop properties of pneumatic actuators. By using the open-loop component of the actuator stiffness as a primary component of stiffness simulation in a haptic interface, the system requires a comparatively small component of simulated stiffness from the closed-loop control of the actuator. A passivity analysis is presented describing how the presence of an open-loop stiffness enhances the range of passivity of haptically simulated high-stiffness surfaces. Experimental results both with and without a human operator are presented that demonstrate the effectiveness of the approach and its enhanced passivity relative to motor-actuated devices.

This paper proposes a control approach that controls the stiffness and force of pneumatic actuator independently. This independent control of stiffness and force removes a primary cause of contact instability when utilizing stiffness or impedance based force control during interaction with stiff environments. Specifically, in typical stiffness or impedance control, since the force is defined in terms of motion variables, the desired force term appears as high gain position feedback when a manipulator is in contact with a stiff environment. In the proposed approach, since stiffness and force are controlled independently, the force appears as an exogenous input rather than as high gain position feedback, and therefore this source of instability is removed. The paper describes the control approach for independent stiffness and force control, which is based on an MIMO sliding mode controller design. Experimental results are presented that demonstrate the effectiveness of the control approach.